48” x 120” x 3” NO SEAL FORM, the largest size added to the family of forms.
*********NOTE: *********
This is a four section hdpe form. There are 4 latches that connect the four pieces of hdpe together. Silicon is recommended to add to the front and back seams where all four pieces meet together to make sure no epoxy leaks.
Your project is easily removed by tapping the sides and back with a mallet. Once removed, you can start another immediately
Please use rubber mallet to tap your cured project out of the form by gently hitting the inside of the sides and flipping over and hitting the bottom. Using excessive force inside on the sides and using a metal hammer will void any warranty.
Please read carefully instructions on how to mix and pour your Epoxy.
Epoxy that does not cure properly will make it impossible to remove your project.
Epoxy that overheats during the curing process will twist and crack the Form, sometimes adhering to the form. Again, making it very difficult to remove your project for the form.
Mold release is not needed but will not hurt if used. Picture may not reflect actual form.