60” Round No Seal Form with 3” sides.
This is a two-piece form that connects with two latches. It's recommended to add a small bead of silicone along the seam where the two parts connect, on the inside and outside of form.
These are No Seal Form
that don’t require any
sealant. Simply knock out
your cured pour out of
the form and start a new
These forms don’t require any sealant or tuck tape.
Your project is easily removed by tapping the sides and back with a mallet. Once removed, you can start another immediately
Please use rubber mallet to tap your cured project out of the form by gently hitting the inside of the sides and flipping over and hitting the bottom. Using excessive force inside on the sides and using a metal hammer will void any warranty.
Please read carefully instructions on how to mix and pour your Epoxy.
Epoxy that does not cure properly will make it impossible to remove your project.
Epoxy that overheats during the curing process will twist and crack the Form, sometimes adhering to the form. Again, making it very difficult to remove your project for the form.
Mold release is not needed but will not hurt if used
Wood not included