18" Round Reusable No Seal Form 3"High
These Forms are made with a single piece of 1/4” HDPE making it very flexible and the sides are 3 “ high and never require sealant. The sides are fabricated at a 1 degree to allow your project to drop out.
These forms don’t require any sealant or tuck tape.
Your project is easily removed by tapping the sides and back with a mallet. Once removed, you can start another immediately
Please use rubber mallet to tap your cured project out of the form by gently hitting the inside of the sides and flipping over and hitting the bottom. Using excessive force inside on the sides and using a metal hammer will void any warranty.
Please read carefully instructions on how to mix and pour your Epoxy.
Epoxy that does not cure properly will make it impossible to remove your project.
Epoxy that over heats during the curing process will twist and crack the Form, sometimes adhering to the form. Again making it very difficult to remove your project for the form.
Mold release is not needed but will not hurt if used
Wood not included